Sheppach-TKG260i_Mitre_Saw

Scheppach mitre saw tkg260i – the mobile workshop for both right and left hand users.
When it comes to cutting wall and floor trim panels – moulding strips – door and window frames: a scheppach mitre saw takes them all in its stride and will produce a clean and precise cut every time. They are easy to transport so are equally at home on site or in the workshop.
A major consideration when choosing the right mitre saw is the motor unit. Both scheppach tkg 260i and tkg 305i mitre saws are powered with induction motors which are quiet and suitable for operating in noise sensitive areas, compared to many others which have noisy universal brush motors and require much more maintenance.
Combination mitre saws which include a sawbench facility are perfect for precise crosscuts, angle and compound angle cuts, but can also be used for ripping. The scheppach tkg 260i gives an impressive 150 mm width of cut and a 40 mm depth of cut when ripping. In angled mode the head tilts through 45 degrees and the base rotates through 45 degrees to allow for sawing bevels, mitres and compound mitres. The saw table measures 410 x 280 mm and is made from a die casting for utmost accuracy. The rip fence is held rigidly in position and will not wander under pressure. To adjust the depth of cut you simply raise or lower the saw table.
The powerful 1.6HP induction motor incorporates a soft start which eliminates any initial jolt start and safety is enhanced by the motor brake which brings the sawblade to a standstill within seconds of releasing the trigger switch. You may feel spoilt for choice when it comes to choosing the right mitre saw: that is until you look the scheppach tkg 260i.

Standard equipment
Diecast aluminium rotary plate and table top, aluminium frame, powder coated, aluminium table plate for ripping cuts, with scale for rippng fence, smooth running induction motor, locking pin for grid positions with additional clamp, workpiece stop for mitre cuts left and right usable, TCT sawblade, tool for changing the sawblade

Specification
Dimensions (L/W/H) 470mm x 460mm x 580mm
Work surface 410mm x 280mm
Sawblade ø /teeth 250mm /24t
Tilt area
– Mitre angle 2° x 45°
– Slope angle 1° x 45°
rpm 2,850
Grid position by 0/15/22.5/30/45
Extraction connector ø 28mm/40mm
Weight approx. 17kgs
Cutting details
Cutting height max at 90/45° 40mm
Cutting width max at 90/45° 150 x 50mm
Cutting height over table 40mm
Cutting depth at 90° 150mm x 50mm
Cutting depth at 45° 95mm x 50mm
Motor 230 V/50 Hz
Input 1.2kW (1.6hp)