Trend Routerbout Hole Cutter

Access to pipes & cables beneath chipboard floors in seconds. For builders, plumbers & electricians.

Includes:
1 x Routabout template,3 x Spacer rings, 1 x Special TCT router cutter,1 x 30mm Plastic guide bush

A 250mm diameter opening can be cut and made good in seconds. Designed for use in new or existing 18mm chipboard or similar floors. Cuts only the thickness of the board. No waste, the piece cut out is used to make good the floor.
All you need is a plunge router (750 watts or above).
A Unibase may be required for certain makes and models of router.

Specifications
Shank Diameter 1/4 inch or 1/2 inch
For cutting a 250mm opening in chipboard floors
Floor thickness 18mm

Replacement cutter for use on 18mm & 22mm floor thickness.
Choose from List

Guide bush guides the router when using a template.

* Fits directly to Trend T3,T4,T5,T5 MK2, T9,T10 and T11, and some other light duty routers.
* Will fit other makes when used with GB/5, GB/PLATE or UNIBASE Sub-base.

Smaller version of the successful Routabout for access to pipes & cables beneath chipboard floors in seconds. For builders, plumbers & electricians.

A 108mm diameter opening can be cut and made good in seconds. Designed for use in new or existing 18mm chipboard or similar floor.
Cuts only the thickness of the board. A cover is used to fill in the cut-out.
All you need is a plunge router (750 watts or above).
A Unibase may be required for certain for certain makes and models of router.

Includes:
1 x Mini routabout template,3 x Covers,1 x Special TCT router cutter,1 x 30mm Plastic guide bush

Specifications
Shank Diameter 1/4 or 1/2inch
For 18mm or 22mm thick floors

Replacement cutter for use on 18mm & 22mm floor thickness.
Choose from List

Replacement covers for the mini routabout jig, suitable for both 18mm or 22mm thick floors.

Replacement covers for the mini routabout jig, suitable for both 18mm or 22mm thick floors.

Guide bush guides the router when using a template.

* Fits directly to Trend T3,T4,T5,T5 MK2, T9,T10 and T11, and some other light duty routers.
* Will fit other makes when used with GB/5, GB/PLATE or UNIBASE Sub-base.

The Unibase enables routers with non-standard guide bush fittings to accept the range of Trend guide bushes, Will fit directly to most routers.

Line-up pin used with a 16mm plastic bush to ensure concentricity of the cutter to the guide bush when fitting the sub-base. Suits collet sizes 1/4inch, 8mm, 12mm and 1/2inch.
Instructions for fitting
The line-up pin fit into the collet and is plunged through the router base. The line-up bush is fitted into the Unibase and secured. This is then placed over the line-up pin and rotated in order to line up the fixing holes. The Unibase screws are tightened and then the line-up bush can be replaced with any choice of Trend guide bushes. These range from 10mm up to 30mm (GB10 - GB32). For larger diameter cutters a 40mm guide bush (GB40) is available.

Includes:
2 x Line-up pins,1 x Guide bush,1 x Fixing screw pack

Specifications
Diameter 170mm
Thickness 8mm