Mitre Trimmer

Shown with Measuring Attachment

The Mitre Trimmer is an excellent addition to the home framers workshop. If you are currently cutting frame moulding with a power saw, or a cheaper quality suspension saw, then the mitres can be improved to near perfect by trimming them in the guillotine.
The most acceptable method of cutting for the professional framer is with a Morso Guillotine... not power saws!! These guillotines have been on the market for over 50 years and produce a near perfect mitre. So the mitre Trimmer is a practical alternative, and they produce a better mitre than a disc sander.
The Mitre Trimmer's super sharp, solid, hollow ground blades leave a clean, smooth cut. Use the Trimmer to shave off a thin piece of the timber to ensure an accurate 45° cut. First cut the moulding into 4 pieces approximately 5mm (1/4") longer than required. This will allow sufficient length to trim the ends for perfect joints every time.

The Trimmer will trim material up to 125mm (5") wide and 100mm (4") thick. Cuts many angles from 90 through to 45° and can be calibrated to ensure accurate mitre cuts. The Trimmer will cut all types of timber, including very hard woods. Blades can be re-sharpened many times over to maintain a quality cutting edge.

Ideal addition to any workshop, especially if your current power/manual saw is not cutting at exact 45°.